28BYJ-48 Camera Slider Build Review

Well we finally got the28BYJ-48 Camera Slider Build completed and tested and it was interesting project to say the least as it was the first time working with steppers and Arduino together.  The video above walks though what we learned as well as some of the short comings as again, this was not meant to be a full working project yet just one of those experiments to see what was possible for the money.  So what would you need to build something like this?  Well the list is below:

3D Printed Parts:


2 – Mounts for the 28BYJ-48 steppers and the STL’s can be found here (www.thingiverse.com/thing:423357)
1 – Slider, busing and washer with STL found here (www.tinkercad.com/things/bLlyngNpkNL-28byj-48-camera-slide)
1 – 28BYJ-48 adapter to M4 rod can be found here (www.thingiverse.com/thing:251910)

Hardware:


2 – #6-36TPI Rods
1 – #8-36TPI Rod (center screw)
2 – Length of heat shrink
Small Box of #6-36TPI Hex Nuts
Small Box of #8-36TPI Hex Nuts
1 – Small length of 1/4inch 20TPI rod
1 – Tube of epoxy (using https://www.tinkercad.com/things/6Y3Q9gOVh0q-camera-slider-base-ver2)

Electronics: