Since we have been doing a lot in the lab lately with the Arduino, we decided to print a holder from Thingiverse to hold both the Arduino and Perfboard as one unit. Well the STL is great, but the print didn’t come out so good as since the last firmware release on the XYZprinting Da Vinci 2.0 Duo 3D Printer they seem to have dropped the bed temp from 90 deg-C to 70 deg-C which is on the low side we have been using rafts to hold prints down, however with the large surface area this one got away from us and we had edge curling. Watch the video and you can see it happen. Well the world didn’t end and it still worked however it did not look as nice as it could of.
by XYZprinting [XYZprinting,Inc]